Synopsis: A step-by-step guide to planning the layout and sizing and installing the ductwork for the ventilation system of a downdraft range, including considerations for both new and replacement installations.

Early in my kitchen remodeling career, I installed my first range with a downdraft vent. The vent moves exhaust air from the range to the outside through a duct (usually in the floor), making an overhead vent unnecessary. Because they afford an unobstructed view, downdraft vents are great for islands and peninsulas. I thought the first job was going to be difficult and was surprised by how simple it was. The lesson I learned on that job, though, is that good planning is essential. With meticulous planning on the front end of the project, you can eliminate the agony that goes along with careless layout.

Know the duct’s path

To determine the path the duct will follow, you need to know where it attaches to the range and where it exits the building. The shorter and straighter the duct is between these two points, the better the downdraft vent works.

Downdraft-vent ducts don’t have to go straight down through the floor; they can go into a cabinet on either side of the range and then through the floor or toward the back of the range, into the wall and then either up or down. Most downdraft vents go through the floor, though, and careful planning to locate the hole in the floor is essential.

A new kitchen has a flexible layout

Because this project involved a new kitchen-cabinet design, I had some flexibility when I drew a full-size outline of the cabinets and range on a piece of plywood tacked to the kitchen’s subfloor. I measured from the lines representing the back and sidewalls of the range to find the center point for the smooth-walled galvanized duct. I took my time on this critical step because manufacturers’ specifications differ regarding duct placement and sizing. I placed the point of my compass on the center point for the duct hole and inscribed an 8-in. dia. circle (1 in. larger than the duct). Then I verified that the floor joists wouldn’t interfere with the duct location.

After cutting away the subfloor and cutting sections of the duct to the correct length, my crew and I assembled a 5-ft. section of duct with sheet-metal screws and duct tape. A straight section with 90° elbows on each end was secured to the framing with sheet-metal straps made on the job site. Insulation placed beneath the duct helps to reduce vibration and noise.

In this case, I was able to run the duct between the floor joists. If the hole for the duct had landed over a joist, I’d have tried to move the cabinet layout a few inches, which is easier than modifying the floor framing. The same is true when venting through an I-joist system, which usually requires that the ductwork fall between joists. Check with a building official or structural engineer before altering engineered joists.

Fine Homebuilding Recommended Products

Fine Homebuilding receives a commission for items purchased through links on this site, including Amazon Associates and other affiliate advertising programs.

Not So Big House

This book earned author Sarah Susanka a reputation as a small house guru, yet, that wasn’t exactly her goal. This book isn’t about building a small house, it’s about building a smart house, one that matches how we live, and prioritizing beauty and comfort over size.

Buy at Amazon

All New Kitchen Ideas that Work

Kitchens are one of the most important rooms in the house. It's where we pack in the most function and spend the most money, so you want something that's convenient and inspiring — this book will help you get there.

Buy at Amazon

Homebody: A Guide to Creating Spaces You Never Want to Leave

Joanna Gaines may have started as a celebrity designer on HGTV, but she’s proven to be the real deal. This book help you understand how and why good design works so that you can recreate it on your own.

Buy at Amazon