Site-Built Shingle Cutter

My regular shingle cutter is out on loan so I made a simple one out of wood scraps and a piece of angle iron (actually a bed frame I found in someone’s trash).  It took about 45 min. to make and has saved much more than that amount of time on one job compared to cutting shingles with a knife. Plus the crosscuts are perfectly square.

There are a few commercially available cutters but they can be pricey and may not be worth the investment if you don’t do roofing all the time.  [see manufacturer list below]

There are several good YouTube videos of custom fabricated shingle cutters that are slick and put mine to shame. Still, this one is serviceable and most importantly cuts square and clean.

The base is two boxes made from 2x3s each about 2 ft. long with a 1 in. space between them and fastened to 2 – 2x on the bottom and capped with some pieces of plywood. The cutter is a 2 ft. long piece of angle with a 3 ft. long 2×2 handle screwed on top.   The cutter is sharpened at a 45 degree angle on a bench grinder (an angle grinder would work too). The base piece is another piece of angle screwed to the left box and it extends about a foot behind the box frame. A drilled hole in the rear of the angles is the hinge point.

We marked out the shingle manufacturer offset cuts for starter shingles on the right side of the cut table for quick reference when cutting.  The 2×3 backstop on the left side is square to the cutter.

Manufactured shingle cutters:

• Shingle Shark – Guardian Fall Protection  
• Shingle Shaper Cutter – Roof Zone
• Shingle Shear – Howard Tools 

www.mikeguertin.com   IG / @mike_guertin

More ideas for cutting asphalt roofing shingles:

• Cutting Shingles with Shears
• Asphalt-Shingle Cutting Guide
• Easy Shingle Cutting With a Pneumatic Cutter

Fine Homebuilding Recommended Products

Fine Homebuilding receives a commission for items purchased through links on this site, including Amazon Associates and other affiliate advertising programs.

Bosch Wall Scanner (GMS 120)

This wall scanner can locate wood and metal studs with respectable accuracy.

Buy at Amazon

DEWALT Impact Driver (DCF885)

This impact driver has has plenty of power, excellent slow-speed control, and features a trio of LED lights mounted around the chuck that light the work area.

Buy at Amazon

Roofing Gun

This lightweight, pneumatic roofing nailer is capable of driving ¾-in to 1¾-in coil roofing nails and has a depth adjustment wheel to dial in nailing depth on the various shingle types you're likely to encounter.

Buy at Amazon