Replies

1. 
   Chucky | Dec 28, 2008 09:35pm | #1

   Cool.  With names like the Eliminator, the Intimidator, the Antagonizor, and the Annihilator, how can they go wrong ?

1. 
   AitchKay | Dec 28, 2008 09:40pm | #2

   Yah, an' dere made in der Governator's state, too!

2. 
   renosteinke | Dec 28, 2008 09:42pm | #3

   I have posted about them at least twice.

   I have purchased a few of their products, but to date I have used only the "Eliminator" carbide covered blade. I have found it very useful for precise cuts and minor adjustments in poorly supported drywall; it doesn't grab the rock and bounce it all over the place.

   
   

   ---

   Edited 12/28/2008 5:45 pm ET by renosteinke

3. 
   JHOLE | Dec 28, 2008 11:11pm | #4

   Bought and used the flush-cut ........once.

   The POS broke, got stuck in and screwed up the chuck in my PC szall.

   Cost just short of a hunnert to get back to square one.

   Not a fan.

   Remodeling Contractor just on the other side of the Glass City

4. 
   toolbear | Dec 29, 2008 03:16am | #5

   I use the flush cut for the recip saw for fascia repair work. So far, so good.

   I use it in the Makita LiOn recip saw. It releases the blade if it doesn't like the stresses - which it has done. I can make better cuts with less stress on the blades.

   The ToolBear

   "You can't save the Earth unless you are willing to make other people sacrifice." Dogbert