I want to add a recessed heat lamp in a bathroom ceiling. I have access to the attic crawl space above, and know that I have to use an “IC” can, but looking at the home center (H-D) selections I’m not sure what they have is rated for this application. I would appreciate any suggestions as to the correct fixture to use, any special precautions to take and proper trim ring finishing, as well as what wattage bulb to use.
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story

The crew talks about work start times, fire-resistant construction, fixer-uppers, building Larsen trusses, and AI for construction.
Featured Video
SawStop's Portable Tablesaw is Bigger and Better Than BeforeHighlights
Fine Homebuilding Magazine
- Home Group
- Antique Trader
- Arts & Crafts Homes
- Bank Note Reporter
- Cabin Life
- Cuisine at Home
- Fine Gardening
- Fine Woodworking
- Green Building Advisor
- Garden Gate
- Horticulture
- Keep Craft Alive
- Log Home Living
- Military Trader/Vehicles
- Numismatic News
- Numismaster
- Old Cars Weekly
- Old House Journal
- Period Homes
- Popular Woodworking
- Script
- ShopNotes
- Sports Collectors Digest
- Threads
- Timber Home Living
- Traditional Building
- Woodsmith
- World Coin News
- Writer's Digest
Replies
I couldn't locate an IC rated can either, so I build a drywall box to put around the can (note the min. clearances), air and vapour sealed, insulated around and above and put the heater on a timer just in case (30 minutes max).
Don't recall the brand of the heater, but was off the shelf of a box store. IIRC, wattage was 200 (the red bulb). I prefer that to the white bulb, just too bright first thing in the am.
I'll make you a hell of a deal on a couple of bathroom heat lamps.
Brand new - can't remember the brand but they are in my storage if you want them.
Joe H