Replies

1. 
   Paulgern | Jan 22, 2003 09:40am | #1

   bought one last week. put the level on a flat surface with the monitor facing you. turn it on. hold the calibrate button until the number starts to flash. wait 10 secs. rotate level end for end so now you are looking at the back of the monitor. hold the calibrate button again until it reads cal 2. wait 10 secs. its calibrated. that said, i took mine back the next day. the booklet says it has to be recalibrated if the temp changes a few degrees and every couple days. i found it had to recalibrated every time i picked it up.and sometimes the reading did not match the bubble. oh-plumb calibrates like level. set it up, touch the button and rotate end for end. good luck.

   paul

1. 
   sps | Jan 23, 2003 09:58pm | #2

   Thanks, Paul.  That did the trick!

   Shawn @ Stolte Construction