The cutter blades stopped. I removed the side plate. A gear would turn on cut one but not two. The thinness Guage is stopped at the bottom. When I removed the top plate ed the motor shuts off. Any ideas for fixes? Nothing precipitated this except for sitting a few months.
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
With the right approach, you can restore old hardware—whether through soaking, scrubbing, or polishing—giving it a fresh look while preserving its original charm.
Featured Video
Highlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Fine Homebuilding Magazine
Fine Home Building
Follow
-
Fine Homebuilding
Dig into cutting-edge approaches and decades of proven solutions with total access to our experts and tradespeople.
Start Free Trial Now -
GBA Prime
Get instant access to the latest developments in green building, research, and reports from the field.
Start Free Trial Now
Replies
Please specify your model again. I am assuming you are referring to model DW735. A planer. Is this correct?
Correct