Replies

1. 
   andyfew322 | Jan 10, 2008 06:43am | #1

   post it in tool trading

    

    

   "I'd rather be a hammer than a nail"

1. 
   rlrefalo | Jan 10, 2008 06:54am | #2

   thanks,will do

1. 
   rlrefalo | Jan 12, 2008 06:40pm | #3

   going once going twice ? anyone interested ?

1. 
   BossHog | Jan 12, 2008 06:46pm | #4

   You might get more responses if you give more detail. I didn't know what a Delta RT-31 was until I looked it up:http://www.revuebst.com/English/fiche_machinerie.asp?NoMachinerie=2095It would also help if you post your location and some more info about it.
   There are two kinds of people who never amount to much: those who cannot do what they are told, and those who can do nothing else.

1. 
   rlrefalo | Jan 12, 2008 07:40pm | #5

    thanks Boss,  Delta RT-31 is a commercial panel scoring table saw, ten inch blade with scoring blade, or 12 inch blade without scoring blade. Saw has seen very light use in a home based shop enviroment. Originally set for 230/460 3 phase. Now is set for 220 single phase. Still have original motor for easy re-conversion. Right tilt, right side extension table, good 49 inch rip fence. Miter gauge and extension table with t slots. All original tools and arbor bushings. I see them on the equipment auction sites for about 2500., would like to get 2000. Saw is in north central NJ

2. 
   BillHartmann | Jan 12, 2008 08:11pm | #6

   If you have not already done so, post it over at knots.That is where the tea drinking, right pinking in the air, cabinet makers hang out..
   .
   A-holes. Hey every group has to have one. And I have been elected to be the one. I should make that my tagline.

3. 
   rlrefalo | Jan 13, 2008 12:26am | #7

   Thanks bill I'll do that.