I’m planning on installing a water filter system at my kitchen sink and need to drill through the enamal/cast iron sink. The required 1/2″ hole will be drilled near the faucet. What is the perferred method of drilling? Masonry bit or Glass bit, or perhaps a diamond bit? Thanks for your input.
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
You don't have to sacrifice historical elements of a house in the name of energy efficiency.
Featured Video
Highlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
http://forums.prospero.com/tp-breaktime/messages?msg=18306.1
http://forums.prospero.com/tp-breaktime/messages?msg=391.1
http://forums.prospero.com/tp-breaktime/messages?msg=7935.1
http://forums.prospero.com/tp-breaktime/messages?msg=50177.1
http://forums.prospero.com/tp-breaktime/messages?msg=17369.1
http://forums.prospero.com/tp-breaktime/messages?msg=25999.1
http://forums.prospero.com/tp-breaktime/messages?msg=16057.1