I saw in a FHB houses issue where they plastered the a shower wall. You may remember the bathroom, it had a mosaic tile on one of the shower walls and the plaster was tinted with yellow. I am contemplating doing it on my own house. It seems like a really bad idea but I bought this really nice tile and I only have enough for the pan and one wall. My question is; Is this a bad idea (I think I know that answer)? But if I go ahead with it what kind of additives should I put in the plaster mix to prevent mold? thanks
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story

Keeping HVAC systems within the conditioned enclosure can be tough without a basement; one option is to use plenum trusses for the roof, which offer a space for equipment and ductwork.
Featured Video
How to Install Exterior Window TrimHighlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Fine Homebuilding Magazine
- Home Group
- Antique Trader
- Arts & Crafts Homes
- Bank Note Reporter
- Cabin Life
- Cuisine at Home
- Fine Gardening
- Fine Woodworking
- Green Building Advisor
- Garden Gate
- Horticulture
- Keep Craft Alive
- Log Home Living
- Military Trader/Vehicles
- Numismatic News
- Numismaster
- Old Cars Weekly
- Old House Journal
- Period Homes
- Popular Woodworking
- Script
- ShopNotes
- Sports Collectors Digest
- Threads
- Timber Home Living
- Traditional Building
- Woodsmith
- World Coin News
- Writer's Digest
Replies
Greetings red, Sorry for the delay in getting to you. Sometimes these posts don't always get displayed on the board very quickly.
This post, in response to your question, will bump the thread through the 'recent discussion' listing again which will increase it's viewing.
Perhaps it will catch someone's attention that can help you with advice.
Cheers
Get a Peach full,
easy feelin'.
I do beleive I've seen it done too. All i noticed was a good paintjob.
Can you hold the laser level while I shave?
One way to do it would be to use traditional skim-coat plaster, which once it's set up is no longer water soluble the way joint compound is. You can mix a little pigment in as you go. Then wax the surface with a wax tinted a similar but slightly different color. The was finish is nice and soft, and would repel some water.
I wouldn't want to be the guy who got hired to repaint the walls after that though!
Isn't there a waterproof plaster just for this application....Kynes cement, as I recall
Do it just like pool plaster. I'd want a full membrane behind that.Regards, Scooter"I may be drunk, but you're crazy, and I'll be sober tomorrow." WC Fields, "Its a Gift" 1934