Comparing the Bosch 12″ sliding dual bevel GCM12″SD to the Dewalt DWS 780. Would like a Festool but to much money. Any thoughts on the Bosch or Dewalt? Thanks
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
Prescriptive codes don't address the connection at less common angles, so base the connection off more typical ones using bolts, structural screws, blocking, and steel tension ties.
Highlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
I have the DeWalt. It sits on a fold-away rolling stand with side supports. I am very satisfied with it. The lazer is an added bonus. However, I find myself gradually upgrading to Bosch. I have a Bosch table saw on a gravity-activated Bosch rolling stand, and I must say, both saw and stand are second to none! If you are a remodeler/builder either tool is an a good choice. If you are primarily a cabinet builder or a detail craftsman, the Festool is for you.
Those very good quality
.
I think I really would like the Accordian style saws that don't have the slides because you could put them up against the wall and not standing out from it...I don't own one though but I sure think I would like one. I have a Bosch slider that I love....other than you have to be out in the middle of the floor to use it.