I have a Walker turner table saw for near Woodbury tn. As far as I can tell it was made around 1956 or so. It has a 1.5 hp belt driven motor and it’s a 10 inch blade. Someone who had it before me leg it sit in water but I’ve spent a lot of time polishing the top. Pickup only. $150 OBO
Discussion Forum
Discussion Forum
Up Next
Video Shorts
Featured Story
FHB Podcast team chats about adding Larsen trusses to an existing stud-frame home with no additional sheathing.
Featured Video
Highlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Replies
Johnny
you don't have to start a new thread.
just go back to the thread and post a reply. Hell, post a dot and that'll be enough to bring the thread back to the top.
Matter of fact, in memorium to a deceased member of this forum there was developed the "Rez Bump".
known for a post to bring the thread back to the top.
try it sometime.
.
can you post some pictures?
hows the motor? by sitting in water im assuming you mean it sat outside??