Energy, Heating & Insulation Archives - Page 870 of 903

June 12, 2002

We are going to be reroofing part of our 1963 ranch with 4:12 roof.  We're taking it down to the rafters, sistering to the old rafters, and redecking.  This is…

June 12, 2002

Hi All! My first post in this forum! Can anyone tell me how to figure out how many feet of hydronic baseboard heater I will need to heat my attic? …

June 12, 2002

Hi all, I'm replacing a couple stoves in a rental house I own.  Old stoves were LP, but the new one's I'd like to install with nat gas.  These are small…

June 12, 2002

Guys: Need your opinion on foaming the recessed light cans with my foam gun to make them air tight.  I would use the pur- fill poly foam. Would use the…

June 12, 2002

We are finishing an attic in Atlanta GA and are looking at sprayed polyeurathane foam for the sloped ceiling, gables, and kneewalls.  However, we have several unanswered questions.  Contractors would spray the foam…

June 10, 2002

Do they make a recessed light that is air tight? I put four recessed lights in the living room during remodel and I made them air tight. But would like…

June 10, 2002

looking for a Plumber in Southern RI for finished upstairs?

June 8, 2002

I've been involved in contracting for about 15 years.  Most of my experience is primarily in that carpentry side of things.  Recently, I hired an HVAC contractor to install a…

June 6, 2002

Mark, Sorry I don't have an answer for you. If no one else here does, you should try at "The Wall" section of: http://www.heatinghelp.com/ This is right up their alley.…

June 6, 2002

Does anybody have any ideas about heating in front of a 9' section of patio doors.  Hot water heat (existing) is the prefered method.  I'm thinking an in-floor, site built enclosure with finned…