General Discussion Archives - Page 4 of 6158

October 14, 2024

I am installing uponr xpress trsk over a slab.  I will be installing tile over top.  I am going to use 1/4 backer board and was looking for suggestions on…

October 12, 2024

A circuit in my house has a 20amp, 12 gauge circuit on which there are multiple outlets/lights.  After fixing a GFCI circuit, that tested "open ground", I decided to test…

October 11, 2024

Four years ago we had a new Trex deck put on our house.  It is a low porch-like deck and is completely enclosed.   We continually have problems with the lights…

October 9, 2024

I would love to see FHB write an article recommending tools for people with hand arthritis. Most of us face this problem eventually. I am looking for a lightweight drill…

October 9, 2024

As you can see, the wood in my bathroom ceiling is looking a little rough. I've poked at it with a screwdriver and thankfully it's more solid than it looks.…

October 8, 2024

I’m in the process of building a sauna.  I’m a little stumped on the metal roof. I’m using 38” steel panels with 4 ribs. Everywhere i search it shows to…

October 5, 2024

Should I add a block of 2-by lumber between the joists where they go over a wall? Would just some fiberglass insulation be enough? Is anything needed at all?Also yes,…

October 5, 2024

Working on a renovation. I'll be hanging new drywall on my wall, but the ceiling still has its old drywall which isn't being replaced. The wall does have a top…

September 30, 2024

Hello, this is a post and beam house, from inside to out wall assembly is: posts, horizontal t&g sheathing, wrb, 2 layers foil faced rigid foam, strapping, pine shiplap vertical…

September 29, 2024

Is there an easy way to repair a broken cedar shingle that is siding on a home ?  The home is old and sided with boards, with beaver board over…