General Discussion Archives - Page 41 of 6159

September 12, 2023

I have two small sheds with aging asphalt shingle roofs that are now getting to the point of allowing water in. The smaller shed roof area is just over 1…

September 9, 2023

Would appreciate some recip saw demolition blade recommendations.  I've got to cut up a lot of left over scrap wood into smaller pieces for easier disposal.Thank You.

September 8, 2023

Hello. I’m having issues with coping my crown molding. Here are the specs of the crown. 5 1\2 in crown 40/50 for wall/ceiling anglesMy miter saw isn’t big enough to only…

September 8, 2023

When the HVAC turns on the lights in the house momentarily flicker.  LED lights that were supposed to last years burn out in about six months.The house was built in…

September 7, 2023

Good afternoon, I need some help. I had found some rotten exterior vertical trim to the interior/exterior garage door entrance. So like an ok DIY'r, took it out. When I…

September 7, 2023

I am finishing my below grade basement. I put Owens Corning R-5 against the slab walls. Now my question is do I put faced or unfaced batt R-15 between stud…

September 6, 2023

Client has us taking out an old garage and putting in a new one about half again as large. The home was built in 1909. It's clear that the original…

September 4, 2023

Hi all,I'm a retired "want to be" setting up a woodworking shop in my attached, two car garage. I just had a subpanel including 240v added for my new SawStop…

September 4, 2023

Hey friends, I’m now under contract for a property that we intend to build on. Exciting, and scary. Property and location are amazing/beautiful. Have a few days left for inspection.…

September 3, 2023

My basement stair stringers are not properly attached and pulling away from first floor anyone have any advice on how to properly secure them?