General Discussion Archives - Page 6108 of 6158

January 30, 1999

* My 15-year old 1.5 hp ShopVac wet/dry vacuum is extremely noisy and releases a lot of fine dust into the area of operation. Does anyone have experience with quiet/clean…

January 30, 1999

* Kalwall - http://www.kalwall.com or 800-258-9777. Very expensive

January 30, 1999

* In a bathroom as small as this it doesn't much matter where you put the fan. The big problem is Switching because most people leave the fan on only…

January 30, 1999

* I have an older wood frame house that sits very low to the ground (some sills actually rest on the ground) and am experiencing some severe water damage to…

January 30, 1999

* My stucco subcontractor did not mask or tape off the windows. He simply wiped the splatter off with a wet rag. Now there is a film of stucco on…

January 30, 1999

* I am trying to remodel attic into bedrooms, but I need to know the information that must be included in the drawing for the permit. Beside the accurate drawing,…

January 30, 1999

* Short of measuring each wall for the square footage, can you tell me if there is a rull of thumb for pricing sheetrock material? I have approximately 6000 sq…

January 30, 1999

* I have recently stripped, sanded, and reglazed some 6 over 6 double-hung windows. It's been over three weeks, and the glazing putty (DAP 33) is just as soft as…

January 30, 1999

* Could anyone tell me if there is any neat trick or method to easily remove the usually black Grade & Trade Mark Stamping on the back side of plywood…

January 30, 1999

* I am building my own home and am currently putting up non-bearing partition walls. I have been told by a carpenter that these walls should be 1/2" below the…