General Discussion Archives - Page 6130 of 6158

January 11, 1999

* Any body out there in drywall land that has done any steam bending of drywall to to tight radius's? Im going to try it next week and wouldnt mind…

January 11, 1999

* I have a small construction company ( 6 employes) in Wisconsin and have started offering group health insurance as a benifit. The company pays 100% of employee cost &…

January 11, 1999

* Here in Northern Virginia, every sheetrock hanger I know (or have used on a job) glues the board. Whether they are using nails or screws, they wouldn't think of…

January 11, 1999

* Steve, I just had two homes plumbed with wirsbo aquapex. The plumber sold me on it after taking a piece of it and bending it repeatedly until there was…

January 11, 1999

* Done similar to that recently, no repercussions. Pwer company didn't even question it. In our case, we had to shorten the electric peckerhead to clear eaves on a new…

January 11, 1999

* I'm about to buy myself a power mitre saw. I've been thinking about the DeWalt 12 inch units. One is a compound mitre (approx $300) the other a sliding…

January 11, 1999

* I would like to join or start a woodworking co-op in western NY. Any help would be appreaciated. thank you

January 11, 1999

* Is there any performance differences between the standard mild steel drywall trowels and the stainless steel ones?

January 11, 1999

* don't use osb or laun. and whatever you do don't nail the subfloor, staple with 7/8 or longer underlayment staples. i suggest using 1/4" birch underlayment. its harder than…

January 11, 1999

* What are my options for diverting water away from my door sill at either end of my J channel.