General Discussion Archives - Page 6131 of 6160

January 12, 1999

* I recently had an addition to my house built. It was traditional frame construction, clad with vinyl siding to match the existing house. When I arrived home one afternoon,…

January 12, 1999

* I'm researching knee pads for an upcoming article and I'd like to hear your preferences. What brand do you like? Why do you like that brand? What work do…

January 12, 1999

* Does anyone have any charts or formulas for cutting crown moldings in a room with cathedral ceilings? thanks RWD2

January 12, 1999

* The house is sealed high(ceiling/attic)and low(crawl space/basement), quality windows have been installed with great care taken to seal to the sheathing, fireplace/heatstove breaths outside air, caulk or foam occupies…

January 12, 1999

* I am planning the winterization of a near waterfront home on the Massachusetts coast. The house is built on concrete pilings and sits roughly 10' high. I have used…

January 11, 1999

* I'm looking for information on gas or electric powered radiant heat systems. I have a 24' x 30' space and would prefer a system that could be mounted to…

January 11, 1999

* I would like to install shelves that are 24" deep, but the biggest shelf brackets I can find are 16". Does anyone make them larger? If so, where can…

January 11, 1999

* Our new jatoba floor was installed last August in a new addition 16X24. It's over a full basement, the heat is a gas fireplace with fan (damn dry). The…

January 11, 1999

* I am remodeling a 1920 Colonial Craftsman house in Cleveland Ohio. I got the shinglevent II at the ridge and continuous vents at soffits. The front of the gable…

January 11, 1999

* Any body out there in drywall land that has done any steam bending of drywall to to tight radius's? Im going to try it next week and wouldnt mind…