General Discussion Archives - Page 6133 of 6158

January 9, 1999

* I'm considering retro-fitting radiant floor heat on the first floor of my home. I have a full, unfinished basement so access is not a problem. I also have all…

January 9, 1999

* Jarvis, I was taught that the higher the blade is, the more likely it is to force work down onto the table, which is a good thing. If the…

January 8, 1999

* Rick; Didn't you ever hear of the old wive's tail that hot water in the ice cube tray freezes before cold water? You have to look beyond Physics and…

January 8, 1999

* Our rebuilt kitchen will have a breakfast bar or pass through between the kitchen and the dining room. How do I hang or support the upper cabinets. The end…

January 8, 1999

* Has anyone used the drywall sanding kit from FibaTape. It uses a sanding screen rather than paper allowing the dust to be sucked into your shop vac. I was…

January 8, 1999

* Looking for any info. (good or bad) on fiber-cement roofing used here in southern california. Anyone with anything to share?

January 8, 1999

* FredL-As a P.E., I take exception to your solution to "overbuilding" by going to the next size I beam versus hiring an engineer. Did you check your beam for…

January 8, 1999

* Looking for information on nailers to install beveled siding and exterior trim. Also would like to know about the type of nails available for such. Thanks.

January 8, 1999

* Can anyone give me the pros and cons of using single pane glass vs insulated glass? We are building a 3 season room which will have all screen in…

January 8, 1999

* We plan to use a wood fired boiler to heat a radiant heated floor system. I am interested in real-life experience with these, both inside and outside types. Specifically…