General Discussion Archives - Page 6137 of 6160

January 7, 1999

* I have done some digging and found a possible culprit for our cycling furnace. On cold mornings, our furnace cycles on and off once about every 2 secs or…

January 7, 1999

* I am thinking of installing a Norway or Red pine floor in a bedroom. Any recommendations on a quality brand name poly finish would be appreciated.

January 7, 1999

* Will it really be "concrete" or will it be Gypcrete(tm) or similar? what will the finished floor be? if it is finished concrete or tile, cleaning up the mess…

January 7, 1999

* I've got a 99 yo home with Plaster Walls and Ceilings. The plaster is over lath and there is cellulose insulation behind the lath. I want to replace the…

January 7, 1999

* Looking for the best tablesaw for around $500. It seems that you have to go $600+ from what I have seen to get a decent saw. I want to…

January 7, 1999

* I am planning to build a house this year and was looking at adding extra space reasonably cheap. I've looked into attic trusses, structural insulated panels, and i-joist rafters…

January 7, 1999

* Major headache here. I have recently purchased a new home in the Olympia Wa. area, it sits at the bottom of a hill(50ft. and probably an 40 degree grade.…

January 7, 1999

* Are floor tiles typically laid half way into the doorway of each room that abuts the floor being covered with tile? (I refer to doorways without doors here.) Since…

January 7, 1999

* Tile-Redi makes a plastic shower pan liner designed to be tiled directly over. It's been written up in FHB (#80, p. 98) and also advertised in the magazine. I…

January 7, 1999

* I am curious what size of gas powered Honda generator I would need to power a 3 1/2 horse compressor and a couple of worm-drive skil-saws? Any ideas on…