General Discussion Archives - Page 6143 of 6158

December 31, 1998

* Can't find Eswa heating foils, made by Alcatel. Anybody have current contact info or source for same?

December 31, 1998

* I do a lot of smaller commercial jobs where only 3 or 4 employees might be working at a time. What measures do any of you take for verifying…

December 31, 1998

* We have a gutted room which won't be completed for several months (no windows, no interior walls, and no insulation). Winters here are freezing and we can close this…

December 31, 1998

* Ok - I'm trying to make an informed decision here. As you know, most everyone is telling me to have vents put in with my new roof. I believe,…

December 31, 1998

* What can be done with a house with square edged plywood subflooring and no blocking installed at the long seams. The plywood seems to go up and down between…

December 31, 1998

* There's obviously less duct involved with going thru the outside wall than thru the attic. But are there any problems with going out the wall with a bath vent?…

December 31, 1998

* Does anyone have the source or information about beam sizing using Microlam beams, or information about beam sizing for gable ends.

December 31, 1998

* I'm interested in building a new home. The home has a little over 4,000 sq ft and after doing some circuit layouts for the unfinished basement that I want…

December 31, 1998

* Just finished a backsplash in 1/2" thick marble. Used wet saw (sliding table under fixed blaed, this was 16x16 tile) from rental center. Didn't note HP, but it was…

December 31, 1998

* We have an upcoming commercial job that has a interior curved wall, radius is 14'. We will be building & installing a band of windows 2' high by 10'…