General Discussion Archives - Page 6146 of 6160

December 30, 1998

* Rick, It's probably easiest to modify the drywall. Just knock the edges off the drywall (I use a utility knife held at an angle), enough that the casing will…

December 30, 1998

* I'm going to install an 11'X13' maple T&G floor. I picked up the material today. First Surprise- It's a lot drier here than where you live. Let the stock…

December 30, 1998

* I realize this is not directly related to Fine Home Building, ---- but this hurts. I am a weekend doityourselfer. My fingertips are cracking and splitting all the time.…

December 30, 1998

* I have been contracted to make some raised panel oak doors for a client. His building faces west in Arizona. Back in New England I would seal them up…

December 30, 1998

* I am in need of some advice/warnings about making your own moulding.I am thinking of making a series of moulding to be made into built up, or the "poor…

December 30, 1998

* You might try Northwest Energy 425-778-7277. My info is now a couple of years old, but they used to rep ESWA

December 30, 1998

* We have a upcoming commercial job that has a few curved walls that will have sectional flat glass panels. We will be making the sectional continuis frames on site…

December 30, 1998

* I am about to finish my windows, which have been up for 3 years. They are Pozzi double pane, clear pine. Since they have been up for 3 years…

December 30, 1998

* I live in North Carolina and recently moved into a 1981 home. The TRANE heat pump outside is about four years old. The inside unit appears to be original.…

December 30, 1998

* My dining room is partially cantilivered and gets a little cool in there during winter. What is a good or proper method to insullate the floor. The cantilever is…