Tools for Home Building Archives - Page 25 of 791

December 7, 2011

Ladies and Gents of Breaktime, We're starting a new concept over here at Fine Homebuilding: Before we test tools for the magazine, they will be listed in our online Tool…

December 3, 2011

I have several exterior doors that need entire replacement, including new jambs & so on. I would like to try the kerf type weather stripping (it comes highly recommended) but…

December 1, 2011

I have been planning to get one of these and I like the idea of a cordless one, but have seen a few comments that corded is the way to…

November 30, 2011

I am looking to replace my Senco 18 ga. brad nailer and Senco 23ga. pinner. Actually I have two, one older than the other but I am not fond of…

November 22, 2011

Hi, Going to remove a bit of concrete. It's a 4" slab that I want to lay thin pavers over. I need to make a transition from the new height…

November 12, 2011

My son over filled my Makita MAC2400 air compressor with too much oil and now it won't build any pressure, anything I can do or do I take the cost out…

November 11, 2011

Does anyone have any experience with the 18 ga senco fusion?? I want to get one but am unsure after it has taken so long to be released.  Opinions?

November 10, 2011

I need replacement brushes for my Delta Miter Saw, Model 36-220.  Delta no longer manufacturers this part. Any suggestions on finding a replacement part? Thank You   P.S. If there…

November 8, 2011

I am rebuilding some wood awning and casement windows and have had to replace one section that was beyond repair. The windows have a small groove runing around the outside…

November 8, 2011

What corded drill do you recommend for these 1/4" diameter structural screws? Presumably gear reduction and variable speed but who's? Thanks John