Tools for Home Building Archives - Page 41 of 791

May 16, 2010

I'm thinking of purchasing one of those Leigh FMT jigs for some interior doors I'm going to be building for a remodel I'm currently on.

May 14, 2010

My hole hawg low gear skips so i figure the gears are too worn down and are bypassing each other. The Milwaukee diagram I downloaded shows a lot of gears…

May 11, 2010

I was always paranoid about using a lazer tape measure until I scored Bosch's DLR15K. I think it's even more accurate than using a regular tape measure. Don't get me…

May 10, 2010

I'm almost ready to buy the Tajimi Plumb-Rite plumb bob setter. Does it work as advertised? Kreuzie

May 10, 2010

I have recently ventured into working with Venetian plaster as an alternative to the usual drywall texturing and taping.  I ordered a Marshalltown 16062 8-3/4 x 3-3/4 inch Venetian Plastering…

May 10, 2010

My trusty Craftsman Finish Nailer....just started spraying a mist of oil...when I shoot a nail. I think it is coming out the top. First problem in 20 years! Been oiling…

May 8, 2010

I have 10" table and miter saw blades that need sharpening.  I usually bought new, but Harborfreight has $50 sharpener.  Did anybody use this and I was wondering how good…

May 1, 2010

I have a trowel and taping knives bought about ten years ago. Since I had never worked with drywall before and didn't anticipate ever needing to again, these were just…

May 1, 2010

I have a somewhat aged Generac generator that was made in Japan and is equiped with a Kawasaki engine. I has very few hours on it and it performed very…

April 26, 2010

I think the tool belt is nice... but if I are working with a kitchen or a fine job as floor bar, then I would not have a tool belt…