I was sawing a piece of plywood off the back of my van and didn’t have a sawhorse or an extra hand to support the cut piece. I put my framing square under the cut piece and on top of the other side. That was enough to keep the cut piece level with the other piece and allow me to finish the cut without binding the blade or damaging the plywood.
More There's a Better Way - Fine Homebuilding Reader Quick Tips
View AllUp Next
Video Shorts
Featured Story
This time-tested installation method for flangeless windows ensures smooth operation and provides air, water, and vapor control.
Discussion Forum
Highlights
"I have learned so much thanks to the searchable articles on the FHB website. I can confidently say that I expect to be a life-long subscriber." - M.K.
Video
View All Videos- FHB Podcast Segment: Control Condensation With Exterior Insulation
- FHB Podcast Segment: Building a Paintable Surface Over a Traditional Stone Wall
- FHB Podcast Segment: Advice for an Efficient and Affordable New Build
- FHB Podcast Segment: Is Foam Against Form Boards a Good Idea for a Garage Slab?
View Comments
I've never been good with sawing things in my opinion so while I've got a lot of that sort of thing in storage, I tend to call my mate over to help me out with it less I ruin the matierials I've bought or screw up the saw horse in my enthusiasm to saw through things haha! At the end of the day, I've got the tools, but not a lot of knowhow so I guess it might be time for me to start googling more tutorial videos for that sort of thing hey?